top of page

Can Mother of Pearl Jewelry Get Wet? Rain vs Shower vs Pool

12 hours ago
9 min read

This post contains links to our own Amazon store.

📚 MOTHER-OF-PEARL EARRING GUIDE · EP 01

Can mother of pearl jewelry get wet? Yes, briefly: rain on your earlobes or a quick hand wash rarely hurts the shell if you wipe it and let it air-dry. Showers, pools and hot water are a different story, because soap, chlorine, heat and long soaking dull the shine and slowly loosen the glue holding the shell in place.

Worried a pair will irritate your ears? No earring can promise that for everyone. A pair made of 18K gold-plated 316L surgical steel gives healed ears a solid steel base instead of soft brass. If your piercing is fresh or you have a strong metal allergy, start with titanium first and come back to plated pieces once your ears have settled.

  • Keeps its gold color longer - 18K plating sits over 316L surgical steel rather than brass, the base metal that reacts with moisture.

  • Stays put on a busy day - Leporem never uses magnetic clasps.

  • Made for healed ears and everyday wear - small mother of pearl huggies that sit close to the lobe.

Key Takeaways

  • A brief splash from rain or hand-washing rarely harms mother of pearl, as long as you wipe it and let it air-dry.

  • Showers add soap, shampoo, heat and steam, which can film the nacre and soften the adhesive in the setting.

  • Pools and the ocean are the worst case, because chlorine and salt water dull nacre and attack brass-based plating.

  • Gold plating usually fails from the base metal underneath, so the metal under the gold matters more than most buyers think.

  • Skip hair dryers, metal polish and ultrasonic cleaners; a soft dry cloth and flat storage do the job.

What Is Mother of Pearl, and Why Does Water Matter?

Mother of pearl is the iridescent inner layer of a mollusk shell, made of nacre, the same material that gives pearls their glow. Nacre is built from thin, stacked mineral plates held together by organic material. Those layers bend light into that soft rainbow sheen, and they are also what water, heat and chemicals wear down.

Mother of pearl earrings face a second weak point that most care guides skip: construction. Shell inlays are usually glued into a metal frame, and the metal is often plated. A pair can therefore fail in two ways. The nacre can lose its luster, or the plating and adhesive can give out while the shell still looks fine.

Can Mother of Pearl Jewelry Get Wet? The Rain vs Shower vs Pool Ladder

Mother of pearl jewelry can get wet for a moment, but risk climbs with time, heat and chemicals. Rain or a quick hand wash sits at the bottom of the ladder. Showers sit in the middle because of soap and steam. Hot tubs, pools and the ocean sit at the top, where both the nacre and the plating suffer.

Robinson's Jewelers and Atolea (2025-2026) put it the same way: brief water contact is usually survivable, while prolonged soaking, heat and repeated exposure cause the damage. Dissolved minerals and chlorine can dull the surface over time. The ladder below applies that guidance to everyday moments. The risk levels are our reading of retailer guidance, not lab results.

Situation

Risk to the nacre

Risk to plating and glue

What to do

Leporem huggies (18K gold-plated 316L steel)

Rain on the walk home

Low

Low

Pat dry, then air-dry

Wipe and keep wearing; the steel base is not brass

Washing your hands

Low to moderate (soap splash)

Low

Keep soap off the shell, wipe right away

Same routine; dry the shell first

Sweaty workout

Moderate

Moderate; exercise speeds plating wear

Take them off

Take them off to keep the plating bright longer

Shower

High (shampoo and soap film)

High (steam softens glue)

Remove before you step in

Remove; the steel protects the base, not the shell or glue

Hot tub, sauna or pool

High (heat and chlorine)

High (chlorine is harsh on plating)

Remove

Remove

Ocean

High

High (salt water)

Remove

Remove

Can You Wear Pearl Earrings in the Shower?

Pearl and mother of pearl earrings should come off before a shower. Shampoo, conditioner and shower gel can leave a film on nacre, and hot water and steam can soften the adhesive that holds the shell in its setting. Taking them off takes ten seconds; repairing a loose inlay takes a jeweler.

Earrings get more shower exposure than any other piece of jewelry. Shampoo runs straight down past your ears, conditioner sits there while it works, and the steam lingers. Pearls.co.uk and Dunkin's Diamonds (2025) both note that moisture can seep into drill holes and settings and gradually weaken adhesive. One shower won't pop a shell out. A daily habit can, slowly, and the first sign is often a hairline gap at the edge of the inlay.

Blue Nile and Majorica (2025) add a rule worth borrowing: put jewelry on after cosmetics, hairspray and perfume, not before. Winter makes that harder, because dry hands mean more hand cream and dry hair means more product. Hand cream on your fingertips ends up on the shell every time you adjust an earring, which is a chemical exposure rather than a water one, but it dulls the surface just the same.

Two Things Water Wears Down: The Shell and the Plating

Water damages mother of pearl earrings through two separate failure modes, and telling them apart helps you fix the right problem. Nacre dulling shows up as a chalky, flat surface. Plating wear shows up as a pinkish or darker patch on the metal. A pair can have one without the other.

Failure mode 1: Nacre dulling and micro-crazing

Nacre loses luster when minerals, chlorine and residue build up on its surface. Heat adds a second risk: retailer care guides (2026) warn that forced heat, such as a hair dryer or direct sun, can dehydrate nacre and cause micro-crazing, a web of fine surface cracks. Blasting wet earrings with a hair dryer feels efficient, but a slow air-dry is the safer choice.

Failure mode 2: Plating and base-metal wear

Gold plating rarely tarnishes on its own. According to Jewelers Mutual (2025), the gold layer itself seldom tarnishes; the base metal underneath, often brass or copper, reacts with moisture and oxygen. Once the thin gold wears through at an edge, water reaches that base and discoloration spreads from there.

Plating lifespan estimates vary widely. Atolea and Giva (2026) give ranges from a few months to 2 years in one guide and 2 to 5 years in another, and cite at least 2.5 microns as durable. Both say sleeping or exercising in plated jewelry speeds wear. In practice, that range is the difference between a pair that still glows at a summer wedding and one that looks brassy by spring. Atolea (2026) also singles out pool chlorine and salt water as especially harsh on brass-based plating.

Got Them Wet Anyway? A 6-Step After-Water Checklist

Mother of pearl earrings that got wet recover best with a gentle, unheated drying routine done right away. The goal is to remove residue, pull moisture out of the setting and let the nacre dry slowly. Save these six steps for the next time you forget to take your earrings off.

  1. Take them off as soon as you notice, especially after a shower, pool or ocean swim.

  2. Rinse residue only if needed. After chlorine, salt water or soap, a quick pass under cool, plain water is better than letting the residue dry on the shell.

  3. Blot, don't rub. Press a soft, lint-free cloth against the shell and metal; rubbing grinds residue into the nacre.

  4. Dry the setting edges. Touch the cloth to the seam where shell meets metal, the spot where water hides and works on the glue.

  5. Air-dry flat at room temperature for a few hours, away from the hair dryer, radiator and direct sun.

  6. Store them dry and separate in a soft pouch, so the shell can't be scratched by other jewelry.

If you have a friend who showers, sleeps and swims in the same pair of earrings and wonders why they turned dull, steps 3 through 5 are the part to send her.

How to Clean Mother of Pearl Earrings Without Damaging Them

The safest way to clean mother of pearl earrings is a soft, dry cloth after every wear. Pearls of Joy and Atolea (2025-2026) recommend wiping pieces down after wearing and storing them flat in a soft pouch, and they advise against metal polish and ultrasonic cleaners on pearl and nacre jewelry.

Metal polish strips gold plating and scratches nacre at the same time. Ultrasonic cleaners shake jewelry with high-frequency vibration in liquid, which can loosen glued inlays and drive water into the setting. Both are fine for a solid gold band and both are a bad idea for a glued mother of pearl huggie. If the shell looks flat, a fresh dry cloth and a little patience usually do more than any product.

What We Know vs. What Is Retailer Opinion

Mother of pearl care advice comes almost entirely from jewelry retailers, and those sources partly disagree. One Atolea article says mother of pearl may get briefly wet, while another says the short answer for pearls is no. No independent lab tests on mother of pearl earrings and water turned up in our research.

The points that every source agrees on are the ones worth trusting: heat, chemicals and long soaking are the problem; a quick, dried-off splash is not. Where sources disagree, such as exact plating lifespans, treat the numbers as rough ranges rather than promises, including any you see on a product page.

Which Mother of Pearl Earrings Handle Everyday Life Best?

The mother of pearl earrings that handle everyday life best combine a sturdy base metal, a secure closure and a small, close-fitting shape. No earring makes the shell shower-safe, but the right construction makes the metal parts more forgiving of rain, hand-washing and long days.

  • Base metal: brass and copper are what react with moisture, so a steel base under the gold gives the plating a more stable foundation.

  • Closure: a mechanical closure stays shut when a scarf or a collar brushes past, where a magnet can let go.

  • Shape: small huggie hoops sit close to the lobe, so they catch less shampoo, less hair and fewer snags than long drops.

  • Your ears: healed piercings handle plated steel well; fresh piercings and strong metal allergies call for titanium first.

The Leporem Mother of Pearl Huggie Hoop Earrings meet those criteria: 18K gold plating over 316L surgical steel, so the plating sits on steel instead of brass, and no magnetic clasp, so the pair stays on through a coat-and-scarf commute. That steel base means the gold keeps its warm color through rainy walks and hand-washing better than a brass-based pair would. Before deciding, the clearest thing to look at is how the shell sits in the gold frame.

The Leporem huggies are not for anyone who wants to swim, shower or sleep in earrings without thinking about them. The mother of pearl and the plating still need the same care described above. For people with healed ears who want a small, everyday pair they take off for showers, the 316L steel base and push-to-close design make that routine easy to keep.

Frequently Asked Questions

What happens if mother of pearl gets wet?

Mother of pearl that gets wet briefly usually recovers if you wipe it and let it air-dry. Damage builds with repetition: dissolved minerals and chlorine slowly dull the nacre, and water that seeps into drill holes and settings can gradually weaken the adhesive that holds the shell in place.

Can you swim with mother of pearl earrings?

Swimming with mother of pearl earrings is the riskiest water exposure. Chlorine in pool water can dull nacre, and Atolea (2026) notes that chlorine and salt water are especially harsh on brass-based gold plating. Take mother of pearl earrings off before the pool, the ocean or a hot tub.

Does perfume or hairspray damage mother of pearl?

Perfume and hairspray can leave a film on mother of pearl and dull its glow over time. Blue Nile and Majorica (2025) both advise putting pearl and nacre jewelry on last, after perfume, hairspray, lotion and makeup have dried, so the chemicals never land directly on the shell.

How long does gold plating last on earrings?

Gold plating on earrings lasts anywhere from a few months to several years, depending on thickness and habits. Atolea and Giva (2026) give ranges from a few months to 2 years and 2 to 5 years, cite at least 2.5 microns as durable, and note that sleeping or exercising in plated pieces speeds wear.

How do you keep gold-plated earrings from tarnishing?

Gold-plated earrings stay bright longest when you keep them dry and away from chemicals. Remove them for showers, swimming and workouts, wipe them with a soft dry cloth after each wear, and store them separately in a soft pouch. A steel base resists tarnish better than brass, which reacts with moisture.

Can I sleep in mother of pearl huggie earrings?

Sleeping in mother of pearl huggie earrings is possible on healed ears, but it costs plating life. Atolea and Giva (2026) both note that sleeping or exercising in gold-plated jewelry speeds wear, and pillow friction rubs the nacre. Taking huggies off at night keeps the shine longer.

Mother of pearl jewelry can get wet in the rain and survive; it simply cannot live in the shower, the pool or a steamy bathroom. Wipe it, air-dry it, store it flat, and put it on after your perfume and hand cream. If a small 18K gold-plated steel huggie fits that routine, the buyer reviews are the best place to see how the pair holds up after months of everyday wear.

EP 2 is “First mother-of-pearl earrings: will my ears react?”. Subscribe so it reaches you first.

Not sure which size to order? We put every underwear and jewelry measurement into one free Fit & Size Guide (PDF). Pop your email into the box at the bottom of this page and it will land in your inbox. You can also check the panty size chart right now.

 
 
 

Comments


Get our free Fit & Size Guide

© 2020-2026 ENA Co., Ltd. All rights reserved. 

Privacy Policy · Terms of Service · Contact

Leporem is a registered trademark of ENA Co., Ltd.

bottom of page